Hi I am just finishing installing a late 80`s MG Metro engine into my Midtec Bronze.
The previous set up was a standard early Metro/Allegro radiator with matching expansion tank,waterpump with bypass hose,and single outlet thermostat housing.
I have installed the MG Metro engine as standard,so no bypass hose and the MG thermostat housing with the small bypass outlet but without the sandwich plate as it wont fit under the bonnet. I`ve retained my original radiator.
My question is I now have two small bore outlets to go to the expansion tank.
One is the original from the top of my radiator and the new one from the MG Metro thermostat housing so do I need them both?
I`m thinking I should keep the MG Metro one as it provides the bypass facility and block off the radiator outlet.
I`m trying to keep the pipework to a minimum but could connect both if needed.
So any thoughts......
Regards Andy