engine to bulkhead tie bar

Ask questions on technical aspects and problems!

A different section under here for each of the models.

Moderator: The Midas Forum Staff

engine to bulkhead tie bar

Postby mickyb » Sat Jul 11, 2015 10:36 pm

The first of many questions i am sure, is it possible to get to the back of bulkhead by removing the dashbord ?
The tie bar has partly pushed through the bulkhead, i was thinking if i made a longer mounting bkt, for the engin
side and one for the inside and bolted them through, is there a better way of doing it ? any other ideas most welcome.
mickyb
 
Posts: 15
Joined: Wed May 20, 2015 9:18 pm

Re: engin to bulkhead tie bar

Postby Stuart » Sun Jul 12, 2015 8:19 am

I'm fairly sure that area will be visible below the dashboard area. The distance from engine to bulkhead is shorter than on a mini too.
User avatar
Stuart
 
Posts: 1719
Joined: Tue Dec 02, 2008 8:29 pm
Location: Derbyshire

Re: engine to bulkhead tie bar

Postby mickyb » Tue Jul 14, 2015 10:28 am

Thanks for that info, did not notice that it was shorter, i am on a big learning curve with this one !!
Thanks again
mickyb
 
Posts: 15
Joined: Wed May 20, 2015 9:18 pm


Return to Technical and Problems

Who is online

Users browsing this forum: No registered users and 4 guests

cron