Midas Cars Forum - www.midascarsforum.com

This forum is for Midas and Midtec Bronze enthusiasts. The Midas is a British car designed as a replacement for the Mini Marcos.
https://midasownersclub.co.uk/newforum/

Modifying drive flanges

https://midasownersclub.co.uk/newforum/viewtopic.php?t=2346

Page 1 of 1

Modifying drive flanges

Posted: Wed Apr 22, 2015 9:58 pm
by wolfie
Has anyone ever modified drive flanges to enable fitting alloys with a different PCD? I'm assuming its a case of plugging the original stud holes a re drilling new ones to suit

Re: Modifying drive flanges

Posted: Wed Apr 22, 2015 10:11 pm
by b1zbaz
Yes my mate does it at work as a sideline job

Re: Modifying drive flanges

Posted: Wed Apr 22, 2015 10:25 pm
by wolfie
He might be my new best mate then lol but need to figure out what the offset was on factory 13" alloys to make sure I buy something that will fit under the arches and clear the brake calipers

Re: Modifying drive flanges

Posted: Thu Apr 23, 2015 7:38 am
by b1zbaz
Where are you located
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited