Page 1 of 1
Thread question
Posted: Fri Feb 27, 2009 4:09 pm
by Geoff Butcher
There's a threaded hole on the back end of my block where a stabiliser bar is sometimes fitted. It's in very manky condition, so can anyone confirm what thread it is, before I do something rash, like run the wrong tap down it?
Re: Thread question
Posted: Sat Feb 28, 2009 12:38 pm
by rocketron
Dear Geoff, Just checked the 2 threads which secure the stabiliser bracket on 4x1275 blocks: they're all 5/16th UNF. Convention usually has coarse threads into cast iron, but in this instance deffo 5/16th UNF.
Best regards, Ron
Re: Thread question
Posted: Sat Feb 28, 2009 9:50 pm
by Geoff Butcher
Thank you!